安国中药柜生产厂

一、悬挂式不锈钢中药柜安装方法：1、首先检查墙体是否实芯，不能装在空心墙体上，因为空心墙拉力不够，用不了就会烂掉。2、按选定的孔位，用冲击钻在墙面上打孔，将挂墙配件中的膨胀管装入孔中，再用自攻螺钉将主柜与墙面锁紧。闵行不锈钢中药柜,不锈钢中药柜定制,不锈钢中药柜3、主柜安装完毕后，再把台盆放入，调节放平。4、侧柜、置物架安装方法同主柜。5、化妆镜安装：按化妆镜背孔安装规格在墙面打孔，装入膨胀管，然后把螺钉拧入膨胀管到适合深度，挂上浴镜。6、连接好进出水，并检查密闭性，清理现场。二、落地式不锈钢中药柜安装方法：1、将主柜横放，把地脚拧在固定片上。2、将主柜摆到安装位置，调节地脚螺钉到水平。3、主柜安装完毕后，再把台盆放入，调节放平。4、侧柜、置物架安装方法同悬挂式中药柜主柜。5、化妆镜安装：按化妆镜背孔安装规格在墙面打孔，装入膨胀管，然后把螺钉拧入膨胀管到适合深度，挂上浴镜。6、连接好进出水，并检查密闭性，清理现场。

A hanging cabinet installation method of stainless steel: 1, first check the wall is solid, can not be installed in the hollow wall, because the hollow wall tension is not enough, will not rot. 2. According to the selected hole position, the hole is perforated on the wall with the percussion drill. The expansion pipe in the wall fittings is loaded into the hole, and the main cabinet and the wall face are locked with the self tapping screw. Minhang stainless steel cabinet, stainless steel cabinet customized, stainless steel cabinet, 3 main cabinet after the installation, and then put into the basin, flat regulation. 4. The installation method of side cabinets and stacks is the same as the main cabinet. 5, cosmetic mirror installation: according to the installation specification of the back hole of the cosmetic mirror, punch holes on the wall and load into the expansion pipe, then screw the screws into the expansion pipe to fit the depth, and hang the bath mirror. 6, connect to the water, check the airtight, clean the scene. Two, landing cabinet installation method: 1 stainless steel, the main cabinet horizontally, to anchor screw on the fixing piece. 2. Put the main cabinet in the installation position and adjust the foot screw to the level. 3, the main cabinet after the installation, and then put the basin into flat regulation. 4, side cabinet, rack installation method with hanging cabinet cabinet. 5, cosmetic mirror installation: according to the installation specification of the back hole of the cosmetic mirror, punch holes on the wall and load into the expansion pipe, then screw the screws into the expansion pipe to fit the depth, and hang the bath mirror. 6, connect to the water, check the airtight, clean the scene.